Setting Up The Mobiletouch Wireless Controller - Intellitouch User Manual

28

Setting up the MobileTouch Wireless Controller

The following describes how to assign the MobileTouch wireless controller a communication address for the first
time and to add a MobileTouch controller to a system with a controller already installed.
To manually setup a MobileTouch wireless controller:
1. On the Outdoor Control Panel, press the Reset button.
2.
First Time MobileTouch install:
then press the "F" Filter button. For model i10+3 press the "P" Pool Filter Pump button.
Add a MobileTouch with existing MobileTouch installed:
(solid). Wait a few seconds then press the "V" button or "1" button.
3. The three red System Control LEDs and the auxiliary button LEDs will begin cycling. Wait until the
LEDs stop cycling. The three System Control LEDs will start to blink on and off. The system is ready to
enable the MobileTouch wireless controller. Continue with step 4. See note on page 29 if using
MobileTouch firmware version
Three System
Control LEDs
Go to the Advanced screen.
Getting There
MENU SETUP ADVANCED
4. From the MobileTouch controller Advanced screen,
press the lower buttons 2 and 4 at the same time.
The Service Personnel screen will be displayed.
IntelliTouch Pool and Spa Control System User's Guide
The three red System Control LEDs will be lit (solid). Wait a few seconds
1.160/2.160.
Note: Press V or 1 button to add a
MobileTouch controller with existing
MobileTouch controller(s) already installed.
Auxiliary LEDs
F button
(i5+3, i5S+3 i7+3,
i9+3S, i9+3D)
P button (i10+3D)
The three red System Control LEDs will be lit
Reset button
Press button 2 and 4 at the same time
to access the Service Personnel screen