Intellitouch User Manual page 55

Setting up Set Colors and Color Swim with S Am , S AL ,
or FIBER works
14. Press the top left or right side button to scroll through the available light circuits which can be used for the
Color Set and Color Swim feature. Stop at the circuit name you wish to use. The displayed circuit names
selections are circuit names that were previously assigned (when assigning a circuit function). If there are
no circuits available for selection, refer to "Assigning Circuit Names, " on page 3, and "Assigning Circuit
Functions and Freeze Protection" on pages 39 for more information.
Color Swim: Set the delay time
15. Using the Color Set feature: Press the second button down from the top to scroll through the color
choices. Select the color of your choice. The selections are, White, Light Green, Cyan, Blue, Lavender,
Magenta and Light Magenta.
16. Set Light Position: Press the third button down from the top to set the position of the first light in the
sequence. Position 1 will lead all the other lights in the color changing sequence. Position 2 follows
Position 1 and so on. There are 12 position to choose from. More than one light may be assigned to the
same position number so that their colors may be synchronized. For example, to make the colors swim
right to left, make your right most light POSITION 1. You may need to go back to Step 1 and scroll
through your lights to find the right most light, and set it as POSITION 1.
17. Using the Color Swim feature: Press the forth button down from the top to set the time delay between
this light and the previous position. Use a higher delay time for lights spread further apart. Try five seconds
for all lights and observe the effect. Use different time settings to achieve unique lighting moods and
effects.
18. Press the Save button to save the current setting for the first light.
The previous "CONFIGURE-SELECTION" screen is
displayed. Continue to setup the light circuits. Press the button
next to "NEXT GROUP" to access the next screen for an
additional six circuits. Repeat step 1 through 5 to set the light for
POSITION 2 for Color Swim, and a new color choice for Color
Set. Press Save. Repeat this process until all desired lights have
set colors, positions and delays.
19. Press Back to view the Lights screen. "SPA SAL" on and off
switch is now assigned to the AUX 1 button.
(Continued)
Select the light circuit
Select the color
Select the light position
between lights
SPA SAL
PREV NEXT
PREV WHITE NEXT
PREV 1ST POSITION
NEXT
PREV DELAY 5 SECS
NEXT
LIGHTS/CONFIG/SPA SAL
SAVE EXIT
SPA SAL
COLOR SWIM
NEXT GROUP
SAVE ALL ON
IntelliTouch Pool and Spa Control System User's Guide
45
COLOR SET
CONFIGURE
LIGHTS
ALL OFF SYNC