Feature Circuits; Assign A Circuit Name To A Feature Circuit - Intellitouch User Manual

Feature Circuits

Feature Circuits provide a way to control equipment which is not controlled by an AUX circuit. Typically AUX
circuits are used for high voltage equipment such as pumps and lights, whereas Feature Circuits are used for
valve actuators. However, Feature Circuits can go beyond this definition, and be used in other creative ways.
For example, Feature Circuits may be used to create a Macro circuit in which several other circuits can be
switched on or off with the same button. This is accomplished by first choosing a name for your Macro and
assigning that name to a Feature Circuit. There is a limit of 10 Feature Circuits in the system.
• Valve Actuators - Feature Circuits may be assigned for controlling up to five valve actuators per Load
Center, which requires the installation of the optional Valve Module P/N 520285 that include three actuators
outputs (C, D, and E) per Load Center. For more information about configuring valve actuators, refer to
page 70.
• 2-Speed Pump - A Feature Circuit may be assigned as a way to turn a 2-speed Filter Pump to high speed.
• Spa Spillway - A Feature Circuit may be assigned to activate the Spa Spillway effect, where in a pool/spa
combination, all of the pool water can be diverted to the spa then spill back into the pool.

Assign a Circuit Name to a Feature Circuit

Note: When assigning circuit names in the Indoor Control Panel, use the written list of circuit names
and assigned buttons for the Outdoor Control Panel to make sure that they match.
1. Press the button next to the circuit that you wish to assign a name to.
A small arrow pointing to the name is displayed.
2. Use the Up and Down buttons to scroll through the list of preset
circuit names (see page 37). If the preset circuit names are not
suitable, you can create a custom name (see page 38). Press the Back
button twice and select "Create Custom Names" to create a custom
circuit name.
3. Press the Save button to save the Feature circuit name and return to
the Feature screen.
4. To add another Feature circuit, press the button next to FEATURE
to add another Feature circuit and repeat step 1, 2 and 3.
5. Press the Exit button to return to the main screen.
To view Feature circuits from the main screen: Press the DISPLAY
button until the Feature circuit screen is displayed. The F icon located in
the middle lower part of the screen indicates that Feature circuits screen is
selected.
MENU/SETUP/ADV/AUX/NAME/FEATURE
ALL LIGHTS
EDGE PUMP
WATER FALL
F
MENU HEAT LIGHTS
Feature circuits screen
IntelliTouch Pool and Spa Control System User's Guide
79
CLEANERS
MON 4:32AM
AIR TEMP 92˚
DISPLAY