Intellitouch User Manual page 61

To display the assigned MagicStream circuit on the Lights
screen:
5. From the main screen, press the Lights button on the
bottom of the screen.
6. Press the right side button next to "CONFIGURE" to
assign the previously assigned MagicStream laminar
circuits to the "Lights" screen. Note: The screen on right
shows IntelliBrite light circuits already displayed on the
"Lights" screen. The MagicStream circuits are not
displayed until assigned to the "Lights" screen.
7. Press the button next to "NONE" to assign a laminar
light circuit to the selected button.
8. Press the top left or right side button to scroll through
the assigned light circuits. Select the previously assigned
MagicStream circuit name (i.e. Pool Laminar 1) or AUX
circuit. Repeat this step for other laminar circuits (i.e.
Pool Laminar 1).
If there are no circuits available for selection, refer to
"Assigning Circuit Names, " on page 35, and "Assigning
Circuit Functions and Freeze Protection" on page 39 for
more information.
9. Press the SAVE button on the bottom of the screen.
Press the BACK button to return to the main screen.
The MagicStream laminar circuit will be displayed on the
"Lights" screen, as shown below.
To activate the MagicStream features, see the next page.
ntelliBrite
I
button for
Color and
Mode Light
show
SPA LIGHT
POOL LAMINAR 1
POOL LIGHT POOL LAMINAR 2
INTELLIBRITE MAGICSTREAM
NEXT GROUP CONFIGURE
LIGHTS
SAVE ALL ON ALL OFF SYNC
Lights screen using IntelliBrite lights
and MagicStream laminars
SPA LIGHT
POOL LIGHT
INTELLIBRITE MAGICSTREAM
NEXT GROUP CONFIGURE
LIGHTS
SAVE ALL ON ALL OFF SYNC
POOL LAMINAR 1
PREV
PREV NOT APPLICABLE
PREV
NOT APPLICABLE
NOT APPLICABLE
PREV
LIGHTS/CONFIG/POOL LAMINAR 1
SAVE
MagicStream circuit
buttons
MagicStream
button for
laminar
features
screen
IntelliTouch Pool and Spa Control System User's Guide
51
NEXT
NEXT
NEXT
NEXT
EXIT