Priming Parameters (Intelliflo Vs 3050) - Intellitouch User Manual

IntelliFlo VS 3050 and VSF +SVRS Pump Setup

Priming Parameters (IntelliFlo VS 3050)

The Intelliflo VS 3050 pump priming parameters allow the priming speed and duration length/time selection. The
priming speed can be set from 400 RPM to 3450 RPM. The duration time can be set from 0 to 5 minutes, in
one minute increments. Note: If the IntelliFlo pump is powered on, and a priming parameter is set to a
time greater than 0 minutes, the priming speed will be used from that period (assuming the priming
speed is greater than the speed being requested).
Getting There
MENU SETUP EQUIPMENT INTELLIFLO
Select the
IntelliFlo
VS 3050
pump
To set the IntelliFlo VS 3050 priming parameters:
1. From the main pump screen, press the left side button next to the IntelliFlo VS 3050 pump. Note:
IntelliFlo VS 3050 pump can only be assigned as pump #1, #2, #3, or #4.
2. On the next screen, press the left side button next to "PRIMING PARAMETERS."
3. From the next screen you can set the pump priming time and speed:
Set priming time: Press the top left or right side button to set the priming time from 0 to 5 minutes, in
one minute increments.
Set priming speed (RPM): Press the priming speed left or right side button to set the pump priming
speed from 400 RPM to 3450 RPM.
PRIMING TIME
PRIMING SPEED
4. Press the lower SAVE button to save the settings.
5. Press the EXIT button to return to the Equipment screen. Press EXIT again to return to the main screen.
IFLO VF 3050 #1 POOL
IFLO VS 3050 #2 SPA
IFLO VSF+SVRS #3
IFLO VS 3050 #4 AUX 3
NEXT GROUP OF PUMPS
MENU/SETP/EQUIP/IFLO/SELECT
BACK EXIT
PRIMING TIME 5 MIN
PRIMING SPEED 1000 RPM
MENU/SETP/EQUIP/INFLO4/PRIMING
BACK
(Continued)
Press this
button to
access the
PRIMING
P ARAMETERS
screen
Set priming time
Set priming speed
NEXT
IntelliTouch Pool and Spa Control System User's Guide
PENTAIR IFLO VS 3050
IFLO VS 3050 #4 SPA
SET PARAMETERS
ASSIGN CUSTOM FLOWS
INTELLIFLO STATUS
MENU/SETP/EQUIP/INTELLIFLO
BACK SAVE EXIT
67