Section 2 - Operating The Intellitouch System; Main Screen (Indoor Control Panel And Mobiletouch Wireless Control Panel) - Intellitouch User Manual

(Indoor Control Panel and MobileTouch Wireless Control Panel)
Heater Enabled Indicator
(Flame): Flickers when heater
is on. Sun icon indicates solar
is selected in Heat menu.
Spa or (HI-TEMP) Mode: For
shared (i5+3, i7+3, i9+3) and
dual (i10+3D) equipment
systems; switches on filter
pump, rotate valve actuator
(to isolate spa water from
pool water), and fires heater.
For single body equipment
systems (i5S+3, i9+3S); Use
this button to set pool or spa
to HI-TEMP (temperature)
setting.
Flame Icon:
Displays when Heater is on
for SPA or POOL.
SPA: Displays when SPA or
POOL button is pressed to
activate spa or pool mode.
Displays current and actual
spa or pool water
tempterature setting.
Menu Button:
Access IntelliTouch menu
screens (see page 8).
Heat Button: Access
the "HEAT" menu: Adjust
pool and spa water
temperature and setup
heating source (see
page 10).
Main Screen
Note: For information about the KEYPAD LOCK feature, see page 80
POOL or (LO-TEMP) Mode: Press POOL button to switch on
filter pump and heater, (if heater is enabled). For shared
equipment systems (i5+3, i7+3, i9+3); valves will rotate to pool
position. for "Single Body" systems (i5S+3, i9+3S); Use this
button to set pool or spa to LO-TEMP (temperature) setting.
MAGICSTREAM
SPA 89˚ F
SET TEMP 100˚ F
MENU
M
Main screen indicator
1
Display screen #1.
(Shows AUX circuits for
main Load Center.)
For additional expansion
centers, Display #2, #3,
and #4 can be selected.
F
Feature Circuit screen.
- Press the DISPLAY
button to toggle
between screens.
Operating the IntelliTouch System
AIR 77˚ F
PH 7.5 ORP 725
DEC 13 11:32 AM
M
HEAT LIGHTS DISPLAY
Lights Button: Access
the Lights screen.
Operate and setup
lighting effects using
IntelliBrite, SAm, SAL,
and Fiberworks colored
lighting.
IntelliTouch Pool and Spa Control System User's Guide
7
Section 2
Green LED: Circuit LED
indicator illuminates when
button is pressed to activate
circuit.
Auxiliary (AUX) circuit
Buttons (10): Use
buttons to switch
equipment on or off.
(lighting, pump,
automatic pool cleaners,
jet pumps and fountains).
Day and system time.
Current air temperature.
Display Button: Access
the following screens:
Main Screen: Displays
M
up to ten (10) AUX
circuits for various
equipment control
various equipment.
Display #1 (#2, #3, #4):
1
Displays equipment
circuits connected to
main Load Center (1).
Also can display
additional installed
expansion centers #2,
#3, #4 (i5x, i10x).
F Feature Circuits:
Use "Feature" circuits to
assign additional circuits
to controll valve actuators
for water features, spa
spillway, 2-speed pump,
and macro circuits.