Erasing Outdoor Contrl Panel Memory (Factory Default) - Intellitouch User Manual

Erasing Outdoor Control Panel Memory (Factory Default)
The Outdoor Control Panel programmed memory can be erased and returned to the factory default settings.
System information such as feature circuit configuration, operation and display is retained at the main Load
Center Outdoor Control Panel and all Indoor Control Panels and MobileTouch controllers. If the memory is
erased in the main Outdoor Control Panel (located in the Load Center or Power Center), system information
retained in the Indoor Control Panel or MobileTouch is automatically downloaded. This feature is important in
case of accidental memory loss and to ease board replacement. If there are multiple Expansion Center, iS10
Spa-Side remotes, or Indoor Control Panels, each one of the controllers will need to be manually enabled (see
pages 26 and 27 for details). For instructions about erasing system memory from both the Outdoor Control
Panel and Indoor Control Panel, refer to "Erasing the System Memory," page 84.
To reset to the factory default settings:
1. On the Outdoor Control Panel, press the RESET button.
2. The three red System Control LEDs are lit for about ten seconds.
3. While the red LEDs are lit, press one of the following buttons
• For models i5+3, i7+3, i9+3, i5S+3, i9+3S, and i10+3D, press button 5.
• For models i5x, i10x, press button 7.
4. The System Control LEDs will switch off then on completing a normal system restart. Wait until the system
has returned to "AUTO" and "POOL" modes before resuming operation.
LEDs (System Control)
Main Outdoor Control Panel (Located in the Load Center or Power Center)
5 button
(i5+3, i7+3, i9+3,
i5S+3, i9+3S,
i10+3D)
7 button Reset button
(i5, i10x)
IntelliTouch Pool and Spa Control System User's Guide
97