Manually Enabling Expansion Centers - Intellitouch User Manual

26

Manually Enabling Expansion Centers

The following describes how to manually enable an additional Expansion Center containing the Outdoor Control
Panel).
Note: For information about how the IntelliTouch automatically enables wired controllers, refer to the
"Automatically Enabled Wired Controllers,'' page 25.
Up to three (3) additional Expansion Centers can be installed in the IntelliTouch system. The IntelliTouch system
automatically assigns the "main" Load Center or Power Center as number 1, and other additional Expansion
Centers as number 2, 3, or 4. An Expansion Center (Load Center or Power Center) includes an Outdoor
Control Panel (model i5x or i10x) which is connected to the main Load Center or Power Center.
Note: If the first Expansion Center was installed at the same time as the main Load Center or Power Center, it
will automatically be assigned as number 2. Other additional Expansion Centers need to be manually assigned.
To manually enable additional Expansion Centers:
1. On the Outdoor Control Panel, press the Reset button.
2. The three (3) red System Control LEDs will be lit (solid). Wait a few seconds then press auxiliary Button 1.
The three red System Control LEDs will begin flashing. The system is ready to enable additional Expansion
Centers.
3. On the Expansion Center, press the Reset button and wait a few seconds, and press Button 1. The System
Control LEDs on the Expansion Center will begin flashing.
IntelliTouch Pool and Spa Control System User's Guide
Three System
Control LEDs
Button #1
Main Outdoor Control Panel (Located in the Load Center or Power Center)
Reset button