Configuring Valve Actuators (Controlled By Aux Or Feature Circuit) - Intellitouch User Manual

78

Configuring Valve Actuators (Controlled by AUX or Feature Circuit)

All IntelliTouch systems can drive two auxiliary valve actuators (A and B) for applications such as solar heating
and water features. With the addition of the Valve Module (P/N 520285), installed in the Load Center or
Power Center, the system will accommodate up to three additional actuators (C, D, and E). An AUX circuit or
FEATURE circuit can control auxiliary valve actuators. By using Feature circuits to control valve actuators, you
can conserve your AUX circuits for high voltage relays for controlling pumps and lights. Use Macros to couple
valve actuators with AUX circuits for specific applications.
Note: All Personality boards (including i5x and i10x) has two valve outputs A & B. With the addition of
the Valve Module (P/N 520285) board that connects to the Personality board, three additional valve
operators can be added to the system.
Configuring Valve Actuators
Note: If Expansion Centers are a part of the system, before this screen, you must select which main
Load Center or Power Center you wish to configure. The Load Center or Power Center number
matches display number (1 through 4).
Go to the Configure Valves screen.
Getting There
MENU SETUP ADVANCED CONFIGURE VALVES
1. Select the button next to the valve actuator you wish to
configure. Keep pressing the button until you find the circuit
name which you would like to use to control the valve actuator.
Valve A: Resides on the IntelliTouch Personality board. If
solar heating is setup AND NOT configured as a heat pump,
then this valve is dedicated for controlling the solar heating
valve actuator.
Valve B: Resides on the IntelliTouch Personality board next to
Valve A.
Valves C, D, E: Reside on the optional Valve Module board
that may be plugged into the IntelliTouch Personality board in
any Load Center or Power Center.
2. Repeat the above steps for each valve actuator.
3. Press Save when done.
4. Press Exit to return to main screen.
IntelliTouch Pool and Spa Control System User's Guide