Is4 Spa-Side Remote Controller; Mobiletouch Wireless Controller - Intellitouch User Manual

Pool and spa control system
Table of Contents

Advertisement

iS4 Spa-Side Remote Controller

The iS4 Spa-Side remote controller is a double-insulated, waterproof device that is UL (1563) listed for
installation at the water's edge. The iS4 is typically installed at the tile-line of the spa wall, or in the deck within
arm's reach of a spa occupant. The iS4 provides remote switching of up to four control circuits from the spa or
nearby location. Use the iS4 for switching on the spa pump and heater or other auxiliary equipment (i.e., lights,
jet pump, air blower, etc.). The red LED status light glows steady when in spa mode and flashes while the spa
is heating. For iS4 button assignment information, see page 81.
Red power LED
indicator
1
2
iS4 Spa-Side Remote Controller
(Wall or tile mount)

MobileTouch Wireless Controller

The MobileTouch wireless controller provides the same functionality as the IntelliTouch Indoor Control Panel. It
has an operating range of up to 300 ft. from the MobileTouch transceiver antenna (line of sight) which is
typically located near the IntelliTouch load center. The optimum wireless transmit and receive range may be
affected by physical obstructions, (especially those containing metal), weather conditions, and geographical
features.
The MobileTouch controller screen is an LCD (liquid crystal display) which can be sensitive to sunlight. When
exposed for extended periods the LCD screen will heat up and go black. If this happens, place the remote in a
shaded area and allow the screen to cool down. Do not attempt to adjust the contrast or the screen will be
unreadable when it eventually cools. When used outside, keep the remote
covered or in a shaded area. Prolonged exposure to sunlight may
permanently damage the unit.
Do not plug in the AC adapter to a power source within five
WARNING!
(5) feet of the pool and spa. Canadian installations require a minimum of (3)
meters from pool water. Do not recharge outdoors. Only use Pentair Water
®
Pool and Spa
approved AC adapter transformer.
The MobileTouch wireless controller is water resistant and can be exposed
to temporary splashing or wet hands. However, the controller is not intended
to be submersed. Remove unit immediately if it is dropped in the water or
exposed to rain. Store the unit indoors in a dry environment. Be sure the
gold charging contacts are dry before charging.
MobileTouch Wireless Controller (Previous Model)
The previous model of the MobileTouch wireless controller and Transceiver antenna cannot be used with the
latest model of the MobileTouch wireless controller and Transceiver antenna. Both models cannot coexist in the
same IntelliTouch system.
4
3
4
3
2
1
Red power
LED indicator
iS4 Spa-Side Remote
Controller (Deck mount)
IntelliTouch Pool and Spa Control System User's Guide
Note: IntelliFlo VF or VS pump
flow rate (GPM) or speed
(RPM) can be controlled from
any two iS4 buttons. For more
information, see page 81.
MobileTouch Wireless
Controller
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pool and spa control system

Table of Contents