Feature: Color Set; Fixed Colors Screen; Fixed Colors: Hold/Recall Feature - Intellitouch User Manual

Setting up IntelliBrite LED lights

Feature: Color Set

The "Color Set" SAm Style feature allows any combination of up to 12 IntelliBrite lights, and SAm, SAL and or
Fiberworks lighting (see page 42) to be preset to specific colors. To enable this feature, first select the light
color from the "Colors" screen, then press the button next to "Color Set" to change the lights to the selected
color. Note: If the light was not previously on, after pressing the COLOR SET button, no illumination will
occur for approximately six (6) seconds followed by the "COLOR SET" feature selection. If the light was
previously on, after pressing the COLOR SET button, the previously selected color will momentarily
illuminate, no illumination will occur for approximately six (6) seconds followed by the "COLOR SET"
feature selection.

Fixed Colors Screen

There are five (5) fixed colors to choose from to create a spectacular underwater lighting effect. The fixed
colors are: Blue, Green, Red, White and Magenta. You can switch each light on or off from this screen (see
above) by pressing the button next to the name of the color light. Note: If the light was not previously on,
after pressing a color button, no illumination will occur for up to ten (10) seconds (depending on the
selection), then a white light will momentarily illuminate, followed by the color selection. If the light was
previously on, pressing the color button will momentarily illuminate the previously selected color before
changing to the selected color mode.
To select a fixed color:
1. To access the IntelliBrite fixed "Colors" screen from
the Main screen, press the Lights button on the
bottom of the screen, then press the right side button
next to "COLORS."
2. To activate a color, press the button next to the name
of the color.
Fixed Colors
Hold
Swim

Fixed Colors: Hold/Recall Feature

Use the "Hold" and "Recall" feature to capture and save the selected color and recall it at a later time. Note:
After pressing the HOLD or RECALL button, no illumination will occur for up to 10 seconds, then a
white light will momentarily illuminate, followed by the saved color.
BLUE WHITE
GREEN MAGENTA
RED
HOLD INTELLIBRITE RECALL
SWIM SAM STYLE COLOR SET
LIGHT/INTELLIBRITE/COLORS
BACK EXIT
(Continued)
SPA LIGHT
SPA SAL
MODES INTELLIBRITE
NEXT GROUP
SAVE ALL ON
WARNING - During the off/on switching
process, before the selected color is
displayed, no illumination will occur. This
Fixed Colors
operating mode is normal during the
switching process. During this period the
Recall
pool and spa will be dark and
Color Set
precautions should be taken to avoid
unforeseen accidents. Failure to observe
this warning may result in serious injury
or death to pool and spa users.
IntelliTouch Pool and Spa Control System User's Guide
POOL LIGHT
POOL SAM 1
Press
COLORS
Colors
CONFIGURE
button for
LIGHTS
Fixed
ALL OFF SYNC
Colors
selection
49