Troubleshooting; Frequently Asked Questions (Faq); What Does A '+3' Intellitouch System Mean; How Do I Setup/Configure/Program The 2-Speed Pump - Intellitouch User Manual

Troubleshooting

This section provides information to help you resolve any problems that may occur during installing or using the
IntelliTouch system. If by following the recommended actions you are still unable to resolve the problems please
contact Technical Support, see page vii.

Frequently Asked Questions (FAQ)

What does a '+3' IntelliTouch system mean?

The first number of a "System Personality" indicates the number of high voltage (auxiliary) circuits available
including the filter pump. The '+3' indicates the capability of operating additional equipment without using up
high voltage circuits. Typically this refers to spillway functionality, valve control (see page 78), and feature
circuits (see page 79). A '+3' system also offers moving colored lights, and the ability to create Feature and
Macro circuits.

How Do I Setup/Configure/Program the 2-Speed Pump?

Two-speed pumps operate using two relays and one or more circuits with the IntelliTouch system. The first
relay turns the pump on or off. Assuming this is the filter pump and depending on the system personality, this
circuit is controlled by the Pool, Spa, high temp, or low temp circuits or any other circuit that may be tied to the
filter pump (such as circuits with freeze protection, etc.). The second relay turns the pump from low speed to
high speed. The default condition is low speed, but up to 10 circuits may be assigned to trigger the pump to
high speed. Note: These 10 circuits do NOT turn the pump on.
To configure a two-speed pump relay, refer to "Setting Up a 2-Speed Pump," page 75. For relay location and
wiring, see pages 107 and 108. The 2-Speed pump relay is plugged into the 2-SPD output on the Personality
board. A circuits must be assigned to switch from low to high speed.

Can I turn the Heater On and Change the temperature from the Spa?

The heater may be turned on from the spa using one of two hard wired Spa-Side remote (iS4 or iS10) or by
wireless remote controls (MobileTouch or QuickTouch). Only the iS10 or wireless controllers can change the
temperature from the spa location.

How do I get Solar to switch on?

The system must first be told that solar heat is installed. Go to the Solar equipment screen (Menu > Setup >
Equipment > Solar) and press the YES button to tell the system solar is present. Note: Do not set solar as a
heat pump. Then the heating method must be selected for each body of water. Many options are available
through the Heat screen (see page 71).
IntelliTouch Pool and Spa Control System User's Guide
99