Charging The Mobiletouch Wireless Controller; Using The Mobiletouch Wireless Controller - Intellitouch User Manual

20

Charging the MobileTouch Wireless Controller

When you are not using the MobileTouch controller, place it in the cradle to recharge the battery. This allows the
battery to be fully charged at all times.
To charge the MobileTouch controller battery:
• Plug the AC adapter into an AC wall outlet. Insert the AC Adapter plug into the bottom of the cradle and
place the MobileTouch controller in the cradle. Note: When the MobileTouch controller is placed in the
cradle the display and backlight will be on. After five minutes the backlight will shut off. The
MobileTouch controller and display are always on when seated in the cradle. To turn the backlight on,
press any button.
Charging the battery:
• If the battery screen icon displays one or no bars or the screen is blank, this may indicate that the battery
cannot power the device and needs recharging. During battery recharge, the battery icon bars scroll from right
to left. A complete battery charge takes about 3 to 4 hours. After a complete battery recharge, the battery
icon is replaced with a power plug icon, indicating the battery is fully charged and is now operating on AC
power from the cradle. Note: If the battery requires replacement, only use Pentair Water Pool and Spa
replacement battery (P/N 520815Z).

Using the MobileTouch Wireless Controller

The range of the MobileTouch wireless controller can be up to 300 feet from its transceiver antenna (line of
sight). The transceiver antenna is typically located outside near the IntelliTouch Load Center. The device can be
used all day at full power with a complete battery charge (3 to 4 hours).
To use the MobileTouch wireless controller:
1. Remove the MobileTouch wireless controller from the cradle. The controller can also be used while seated in
the cradle with AC power connected to the cradle.
2. Press the Power button on the front right-side to switch the unit ON. The main screen is displayed. The LCD
backlight will turn off in five minutes if not in use. The battery icon displays three bars, indicating the battery is
fully charged. Press the controller's power switch to switch Off the device.
Note: For details about enabling the
MobileTouch wireless controller, refer to
"Setting up the MobileTouch Wireless
Controller," page 28.
Cradle
IntelliTouch Pool and Spa Control System User's Guide
MobileTouch Wireless Controller
MAIN SCREEN CHECK BATTERY ICONS
Power On/Off button
Ample battery charge. Bars
scroll right to left during
battery recharge.
Sufficient charge left in
the batteries to operate
device.
Batteries will deplete
soon.
Plug icon displays when
the battery is fully
charged and device is
operating on AC power
from cradle.
®