Assign Custom Flows - Intellitouch User Manual

IntelliFlo VF 3050 pump setup

Assign custom flows

From the Assign Custom Flows screen you can assign different (normally higher) flows to circuits/features. For
example you can set your SPA to run at 80 GPM. This way when you switch to spa mode, the pump goes from
the calculated fitter rate of about 28 GPM to 80 GPM while you use the spa. You have a waterfall, and require
60 GPM when it's switched on.
To assign a specific flow to a circuit/feature:
1. From the main pump screen, press the left side button next to the select IntelliFlo pump.
2. On the next screen, press the left side button next to ASSIGN CUSTOM FLOWS.
3. First assign a circuit name. Press the left side button for the selected circuit. Use the PREV and NEXT
button to set the circuit. Then press the right side button to set the flow rate in GPM. The selected circuit/
feature must also be assigned a circuit function/feature. For details about assigning a circuit function and
feature circuit, see page 39 and 79.
4. When finished, press the lower SAVE button to save the setting. The previous pump parameters screen is
displayed. To modify another parameter select a feature from the parameter list. To exit, press the EXIT
button to return to the Equipment screen.
Press this button
go to four
additional circuits/
GPM settings
(Continued)
AUX 7
NONE
NONE
NONE
NEXT PAGE
MENU/SETP/EQUIP/INTELLIFLO/ASSIGN
BACK SAVE
Save button
130 GPM
0 GPM
0 GPM
0 GPM
PREV EXIT
Prev and Next buttons
(use to adjust pump
speed)
IntelliTouch Pool and Spa Control System User's Guide
Press this button
to set the flow
rate (GPM)
63