Table of Contents
Advertisement
100
What are Color Swim and Color Set?
Color Swim: Allows any combination of up to twelve SAm, SAL, IntelliBrite, and/or FIBERworks lighting
circuits to be preset to transition through colors in sequence, giving the appearance of the colors swimming
across the water. The delay in sequencing each light can be adjusted to customize the display for your pool. For
more information see "Setting Up Lighting Options," page 42.
Color Set: Allows any combination of up to twelve SAm, SAL, IntelliBrite, and/or FIBERworks lighting
circuits to be preset to specific colors, such as red, white, and blue for the Fourth of July or red and green for
Christmas.
How do I get S Am /S AL /PG2000 to Synchronize?
There are many ways to configure color changing lights to synchronize on the same colors. The first step is to
assign all color changing light circuits a circuit function such as SAm, SAL, Photon Generator, or Color Wheel.
Refer to "Assign Circuit Functions and Freeze Protection," page 39.
To manually synchronize the lights, use the Sync button on the Lights screen. Refer to page 13 for details about
how to setup the circuits to appear on the Lights Screen.
Light circuits may be controlled to switch on at a particular time and synchronize automatically. This may be
done by using the Smart Start functionality in the Program Screen. See page 15 for programming details.
Can I copy a standard configuration to all the systems I install?
Yes you can but only if you maintain a standard system configuration on a system in your headquarters. An
Indoor Control Panel with a properly wired four conductor patch cable may be used to accomplish this.
-
CAUTION
Do NOT use the Service Panel. This accessory auto erases every time power is removed. It is for
on-site work only.
1. Plug the Indoor Control Panel into a COM port on the Personality board of dedicated system at headquarters.
2. One of several things may happen at this point:
•
The Indoor Control Panel may automatically download the system configuration if its own memory was
erased.
•
You may be prompted to update system personality, see page 86.
•
You may be prompted to select Indoor or Outdoor memory. Always Select Outdoor or you will write over
your dedicated set up.
•
You may have to force a download to the system.
3. This same controller may then be taken to the job-site to configure the system. Switch off the system power.
Open Load Center or Power Center front door, remove the two retaining screws and fold down the Outdoor
Control Panel.
4. Plug in the Indoor Control Panel to one of the COM ports from headquarters.
CAUTION - Be sure to check that the wiring is matching both ends before turning system power back on.
Crossed wiring may permanently damage the system.
5. The procedure is identical to Step 2 above. Plug into the COM port on the Personality board in the Load
Center or Power Center. Again, several different things may happen. Check all the relevant sections to avoid
any problems.
IntelliTouch Pool and Spa Control System User's Guide
Advertisement
Table of Contents
Troubleshooting
