Assigning Additional Expansion Centers - Intellitouch User Manual

Assigning Additional Expansion Centers

4. Buttons 2, 3, and 4 LEDs will be on. Do one of the following:
• If this is the first Expansion Center, press Button 2.
• If this is the second Expansion Center, press Button 3.
• If this is the third Expansion Center, press Button 4.
Note: Do not set more than one Expansion Center to the same number. These numbers correspond
with the numbered display screens on the Indoor Control Panel and MobileTouch wireless controller.
5. The red LED will be on above the selected button number.
6. Repeat the steps above for each additional Expansion Center.
7. After each Expansion Center is enabled, press Reset on the Outdoor Control Panel. Wait until the red Auto
and Pool LED is lit. The system is ready for normal operation.
Main Load Center
(i5+3, i5S+3, i9+3,
i9+3S, i10+3D)
Number 1
Note: Expansion Centers may be a Load Center or Power Center. Connections from the Main Load
Center to an Expansion Center is via the COM port on the Personality board.
Button
2 3 4
Expansion Center
(i5x or i10x)
Number 2
Note: For details about
selecting the Indoor
Control Panel display
that are connected to
additional Expansion
Centers, see page 35.
Additional Additional
Expansion Expansion Center
Center (3 maximum)
Number 3 Number 4
IntelliTouch Pool and Spa Control System User's Guide
27