Setting Up The Remote Control Telephone Feature - Intellitouch User Manual

82

Setting up the Remote Control Telephone Feature

The remote control telephone feature allows you to switch on a feature by calling the Indoor Control Panel via
the telephone.
You can only use this feature the TELSPA needs to be connected to the Personality board COM port, and the
phone line.
The following describes how to switch on your spa remotely. You can also scroll through the list of available
features and set any one of them. This feature can also be used by a macro circuit (see page 80).
To setup the telephone remote control:
Go to the Spa RF and Phone Remotes screen.
1. Press the button next to CONFIGURE MOD-PHONE to access the Phone Remote setup screen.
2. Press the top left button next to NONE.
3. Press the Up or Down buttons to scroll through the available circuit names until you find the function you
would like to assign to the telephone remote. Choose the function you will use most often, for example SPA
allows you to call the system and switch on spa filtration and heating with one command.
Note: If you are using the remote to turn on your spa, you must also enable "MANUAL
HEAT." This allows the heater to always switch on whenever the spa is switched on via the
telephone. For more information, see page 77.
4. Press the Save button to save the setting and return to the remotes screen.
5. Press the Exit button.
IntelliTouch Pool and Spa Control System User's Guide