Adding An Is10 Spa-Side Remote Controller - Intellitouch User Manual

30

Adding an iS10 Spa-Side Remote Controller

Up to four iS10 Spa-Side remote controllers can be installed to allow each iS10 to operate different functions
or to the same functions at different locations. Each iS10 can be assigned as number 1, 2, 3, or 4. If a different
number is not assigned to each installed iS10, then all iS10's are assigned as number iS1. This is useful if you
wish to have the same functions available at different iS10 locations.
The following steps describe how to manually assign each iS10 a number 2, 3, or 4 as required.
Note: If the first iS10 was installed with the main Load Center or Power Center, it will automatically be
assigned as number IS1. Other additional iS10 remotes need to be manually assigned.
To assign additional iS10 remotes as iS2, iS3, or iS4:
1. On the IntelliTouch Outdoor Control Panel, press the Reset button, then press the 1 button. The three (3)
System Control LEDs will start flashing.
2. On the iS10 remote, press the bottom part of the "peanut shaped" toggle switch and the 1 button at the same
time (while the Outdoor Control Panel LEDs are flashing).
3. SHA will be displayed on the iS10 temperature display. The four red iS10 LEDs adjacent to the in-line
buttons will be lit.
4. Assign the iS10 to one of the following:
• If this is the second iS10, press button #2. The temperature display reads IS2.
• If this is the third iS10, press button #3. The temperature display reads IS3.
• If this is the fourth iS10, press button #4. The temperature display reads IS4.
5. The two iS10 red toggle switch LEDs will start to flash.
6. On the Outdoor Control Panel, press the Reset button. The iS10 LEDs will stop flashing. Repeat steps 1-4
for additional iS10 remotes. To configure the iS10 buttons, see page 78.
Note: To disable or enable the iS10 Spa-Side Remote from the Indoor Control Panel or
MobileTouch wireless control panel, refer to "Disable/Enable iS10 and iS4 Spa-Side Remote," on
page 80.
3 LEDs (Auto,
Service and
Time Out
IntelliTouch Pool and Spa Control System User's Guide
)
Button #1
Press Toggle switch and button #1 at the same time
Main Outdoor Control Panel and iS10 Spa-Side remote controller
Reset button