Intellitouch User Manual page 39

Setting up the MobileTouch Wireless Controller
5. Press the button next to LOCK ON ADDRESS to access the next screen.
6. Note: Before pressing the "Lock On Address" move at least 20 to 30 feet away from the
transceiver. Press the button next to LOCK ON ADDRESS to assign a unique frequency for the
MobileTouch controller to avoid inference from other wireless devices within range of the MobileTouch
transceiver.
Note: For MobileTouch firmware version 1.160/2.160:
ADDRESS LOCK AUTO" - Press AUTO to lock on the address. If MobileTouch does not connect then use the MAN
(manual) mode.
You will notice on the UOC the 3 System Control LEDs flashing on and off, as they always have. You will also see a
couple of other leds going on and off. If you watch you will see a Pause, followed by one of the aux 1 - 8 or Heater or
solar leds flash on, then it goes off and a second LED will flash on. Then pause and repeat over and over. Aux 1 - 8
represent number 1 - 8, Heat = 9, and solar = 0. So if you see Pause, Aux2, Aux7, see Pause, Aux2, Aux7,etc. The
system is telling you channel 27. The first Led is the 10's digit, the second LED is the ones digit.
Press MAN on the address lock line, a new screen will appear, saying ENTER LOCK CODE. you can use the left and
right buttons to decrease or increase the number (16 to 47 inclusive). So in this example you would set it to 27. Press
SAVE, you will return back to the prior screen. Press the RESET button on the outdoor control panel and you
MobileTouch is ready to use. If the MobileTouch is not connecting check your wiring connections.
7. After selecting "Lock On Address" the MobileTouch controller is now ready to operate the IntelliTouch
system. The "Service Personnel" screen will be displayed.
8. Press Exit to return to the main screen or proceed with Step 9 if you are adding another MobileTouch
controller while the IntelliTouch outdoor control panel LEDs are flashing.
9. To add another MobileTouch controller at this time, repeat Steps 4 through 8 for each controller, if not,
continue with Step 10.
10. Return the Load Center or Power Center. The System Control LEDs will be flashing. Press the Reset button.
When the "Auto" LED is illuminated the process is complete and the system is ready for operation.
(Continued)
The "Lock On Address" line displays "MAN
IntelliTouch Pool and Spa Control System User's Guide
29