Setup Solar Equipment And Heat Pump Option; Setting Up Solar Equipment; Setting Up A Heat Pump And Gas Heater - Intellitouch User Manual

74

Setup Solar Equipment and Heat Pump Option

Setting up solar equipment

Note: If solar is set then the Valve A actuator will be dedicated to the solar valve actuator.
Setting the system to Heat pump will free Valve A for use on other valves.
Note: Use the "Temp Diff" button at the bottom of the screen to change solar start and stop
temperatures differentials (same as the solar sensor(s) temperature).
Getting There
MENU SETUP EQUIPMENT SOLAR
1. Press either the right or left side button next to the SOLAR selection
to select YES or NO. The solar selections are:
Pool Solar Present: Is the pool using solar heat?
Solar is a Heat pump: Is a heat pump being used for solar heat?
Spa solar present: Is solar heat being used for the spa water?
Solar freeze protection: Enable freeze protection when using solar
heat.
Nocturnal Cooling: Circulate water through the system to lower the
temperature during the night hours. Set the temperature in the Heat
menu.
Note: If a heat pump is being used instead of a solar heating system (see below), press the button next Solar is a
Heatpump to Yes.
Note: For model i10+3D, press YES for each body of water with solar heating.
2. Press the Save button when finished. Press the Exit button to return to the main screen.

Setting up a heat pump and gas heater

If you are using IntelliTouch with a UltraTemp
pump should be installed first in line, then the gas heater. The heat pump will run until the ambient air temperature
is approximately 50° F, at which point the heat pump will
switch off and the heater will switch on and take over. The air
temperature is detected by the solar temperature sensor
located on the IntelliTouch load center. The air temperature is
not adjustable.
To set up the UltraTemp heat pump see the previous page.
To adjust the pool and spa temperature settings from the
Getting There
HEAT screen, press the HEAT button at the bottom of the
HEAT
screen.
SPA MODE: Press the button next to SPA MODE) and
select the heating mode (HEATPUMP/HEATER/OFF).
POOL MODE: Press the button next to POOL MODE to
select the heating mode (HEATPUMP/HEATER/OFF).
Note: Select H PUMP PREF. - If a heat pump is in combination
with other heating systems and you want to use the heat pump
only when it is most effective.
Press the Set button to save the settings. Press the Back button
to return to the main screen.
IntelliTouch Pool and Spa Control System User's Guide
®
heat pump (see previous page) and a natural gas heater, the heat
Back
button
NOTE: INTELLIFLO VF PUMPS - If
the IntelliFlo VF pump is just starting
(requiring a prime) and SOLAR is
available, solar will be delayed for five
(5) minutes to allow the pump to prime.
This only applies for IntelliFlo pump(s)
assigned as a "pool" pump.
POOL SOLAR PRESENT
SOLAR IS A HEATPUMP
SPA SOLAR IS PRESENT
SOLAR FRZ PROTECTION
NOCTURNAL COOLING
SPA
Set button
YES
NO
NO
YES
YES
Press to scroll
through SPA and
select
H PUMP PREF.
Press to scroll
through POOL
and select
H PUMP PREF.