Setting Up Equipment (From The Equipment Screen); Manual Priority Override Of Timed Program Circuits - Intellitouch User Manual

Setting up Equipment
(from the Equipment Screen)
If any special equipment is attached the IntelliTouch Load Center, you need to
setup IntelliTouch to recognize that equipment. From the Equipment screen
you can setup:
• Priority override - Allows you to manually switch off a pre-
programmed circuit.
• IntelliChlor - Setup and view the correct status of the IntelliChlor salt
chlorine electronic generator.
• IntelliFlo VF, VS and SVF pump - Setup and view the current status
of the IntelliFlo pump circuits and program the pump speed (RPM/
GPM).
• UltraTemp heat pump - Setup UltraTemp for heating, cooling or both.
• Solar or heat pump equipment - Lets you adjust solar settings or setup solar as a heat pump (see page 66).
• Two-speed pump - Assign a circuit to switch the filter pump to high speed.
• Pump delays: Cool-down cycle for the heater - Assign a circuit to program a cool-down delay cycle for
the heater
• Valve delay: Enable a delay cycle for valves.
• Spa Options: Automatic spa heating when the spa is manually turned on - Heats the spa using the Spa button
on the Indoor Control panel or the spa-side control, even when the heater is set to OFF in the Heat screen.
This allows you to heat the spa on-demand. Also, on this screen you can override the default "freeze" setting
of 30 minutes to a maximum of 240 minutes. Adjustments can be set in 30 minutes increments (see page 77).
• Fahrenheit or Celsius: Change the temperature settings units to display either Fahrenheit or Celsius.

Manual Priority Override of Timed Program Circuits

The following example describes how the "Manual Operation Priority" feature affects scheduled programs.
Manual Op Priority OFF (Default): If the filter pump circuit or any other circuit is scheduled to run from
9AM to 4 PM and the circuit is manually switched OFF and switched ON within the scheduled program, the
circuit will stop at 4:00 PM as scheduled. In this example the program was not overridden and continued to
operate as scheduled.
Manual Op Priority ON: If the filter pump circuit or any other circuit is scheduled to run from 9AM to 4 PM
and the circuit is manually switched OFF and switched ON within the scheduled program, the circuit will
continue to run for a maximum of 12 hours or whatever that Egg Timer circuit was set to. In this example the
scheduled program was overridden and reverted to the default 12 hour run time.
Note: Manual Op Priority OFF or ON: Using the above examples, if the circuit is manually switched
on before or after the scheduled run time, the circuit will run for a maximum of 12 hours or whatever
the time the Egg Timer has been set to. For information about the Egg Time feature, see page 17.
To enable Manual Op Priority press:
MENU > SETUP> EQUIPMENT > PRIORITY.
1. Press the top right or left button next to
Manual Op Priority and select Yes.
2. Press Save.
3. Press Exit to return to the main screen.
PRIORITY
CHLORINATOR
INTELLIFLO
HEATPUMPCOM
INTELLICHEM
Equipment Screen
PRIORITY SOLAR
CHLORINATOR 2-SPEED PMP
INTELLIFLO PUMP DELAYS
HEATPUMPCOM
SPA OPTIONS
INTELLICHEM DEGREES C/F
MENU / SETUP /EQUIP
BACK EXIT
IntelliTouch Pool and Spa Control System User's Guide
53
SOLAR
2-SPEED PMP
PUMP DELAYS
SPA OPTIONS
DEGREES C/F
MENU / SETUP /EQUIP
BACK EXIT