Important Warning And Safety Instructions - Intellitouch User Manual

IMPORTANT WARNING AND SAFETY INSTRUCTIONS

Important Notice:
Attention Installer: This manual contains important information about the installation, operation and
safe use of this product. This information should be given to the owner and/or operator of this equipment.
WARNING - Before installing this product, read and follow all warning notices and instructions
which are included. Failure to follow safety warnings and instructions can result in severe injury, death,
or property damage. Call (800) 831-7133 for additional free copies of these instructions.
DANGER - Water temperature in excess of 100° F (37.7° C) may be hazardous to your health.
Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the
internal temperature of the body reaches a level several degrees above normal body
temperature of 98.6° F (37° C.). Effects of hyperthermia include: (1) Unawareness of
impending danger. (2) Failure to perceive heat. (3) Failure to recognize the need to leave the
spa. (4) Physical inability to exit the spa. (5) Fetal damage in pregnant women. (6) Unconsciousness
resulting in danger of drowning. The use of alcohol, drugs, or medication can greatly increase the risk of
fatal hyperthermia in hot tubs and spas.
WARNING - To reduce the risk of injury, do not permit children to use this product unless they are
closely supervised at all times.
WARNING - The use of alcohol, drugs, or medication can greatly increase the risk of fatal
hyperthermia in hot tubs and spas.
WARNING -
GAS HEATER: The IntelliTouch® automation control system is designed to supply high voltage
(120 VAC / 240 VAC) to a gas heater and override the thermostat in the heater's control circuit. This automation
control system is intended to control gas heaters with a high temperature limit switch(s) safety circuit ONLY. Failure
to do so may cause property damage or personal injury.
WARNING - Do not use this product to control an automatic pool cover. Swimmers may become
entrapped underneath the cover.
WARNING - For units intended for use in other than single-family dwellings, a clearly labeled
emergency switch shall be provided as part of the installation. The switch shall be readily accessible to
the occupants and shall be installed at least (5) feet (1.52 m) away, adjacent to, and within sight of, the
unit.
CAUTION - Except for listed spa-side remote controls, install a minimum of five (5) feet (1.52 m)
from the inside wall of the pool and spa.
CAUTION - This product is intended for use in swimming pool applications only.
Two Speed Pump Controls Notice (Title 20 Compliance)
Please read the following important Safety Instructions (See page 75 pump speed setup)
When using two-speed pumps manufactured on or after January 1, 2008, the pump's default
circulation speed MUST be set to the LOWEST SPEED, with a high speed overide capability being
for a temporary period not to exceed one normal cycle, or two hours, whichever is less.
IntelliTouch Pool and Spa Control System User's Guide
v