Recording A Preset - High End Systems High End LCD Controller for Studio Color User Manual

3. Press the
below:
4. Press the
5. Use the Page
6. Press the
7. The pages in the loop begin playing back as you recorded
them. The length of time each page "plays" is set by the
Delay construct. Page 1 "plays" for 2 seconds, pages 2 and 3
advance quickly because they are set for 0 seconds, and page
4 "plays" for 5 seconds.
8. Turn the
way clockwise. This speeds up playback, shortening the time
between pages. In fact, you might not even see pages 2 and 3
because their delay times were set to zero.
9. Then turn the
slowing down playback, increasing the time between pages.

Recording a Preset

You can record either the entire loop or any page within the
loop as a preset for one-touch playback later.
• If you want to record the entire loop as a preset, start the
loop running as described in the previous section.
• If you want to record a single page as a preset, press the
<Auto>
page using the Page
1. Toggle the
ON.
2. Press the
4-8 Programming Guided Tour
key. The LCD display appears as shown
<Erase>
key to un-initialize page 5.
<Erase>
key to select page 1.
<Down>
key, located to the right of the joystick.
<Auto>
knob (located under the
<Rate>
knob all the way counter-clockwise,
<Rate>
key to turn OFF the Auto LED, then select the
<Address>/<Preset>
key; it flashes.
<Select>
and
<Up> <Down>
key until the Preset LED is
Studio Color LCD Controller
key) all the
<Auto>
arrow keys.