High End Systems High End LCD Controller for Studio Color User Manual page 80

4. Press the
arrow keys to select
5. Use the joystick to direct the beam at a reference point (wall,
screen, or other surface).
6. Press the
<Down>
below:
7. Press the
<Down>
8. Press the
arrow keys to select a value of
9. The result is a 100% red beam. Press the
the Construct
of the construct from 0 to 255. You should see a red beam of
varying intensities.
10. Press the
arrow keys to select
11. Press the
arrow keys to vary the value of the construct.
• From 0 to about 122 (48%), the beam rapidly increases in
intensity.
• The beam reaches a minimum intensity at about 140
(55%).
• From about 141 (55%) to 255 (FF%), the beam rapidly
increases in intensity again.
12. With the Red construct at full intensity, try varying the Green
and Blue constructs to see the effect on color mixing.
3-18 Using the Construct Keys
key and use the Construct
<Gate>
key, then use the Construct
<Mode>
arrow keys to select
key and use the Construct
<Green>
arrow keys to select a value of .
key and use the Construct
<Blue>
and
<Up>
key and use the Construct
<Mode>
key and use the Construct
<Red>
.
arrow keys to vary the value
<Down>
.
Studio Color LCD Controller
and
<Up> <Down>
and
<Up>
as shown
and
<Up>
and
<Up> <Down>
key and use
<Red>
and
<Up> <Down>
and
<Up> <Down>