Other Connectors; Figure 2-17. Locations Of The Other Connectors On The - High End Systems High End LCD Controller for Studio Color User Manual

Other Connectors

This section describes how to connect cabling to the other
connectors on the controller's rear panel. Because these
other connectors are used in conjunction with advanced
functions described further in Chapters 6 and 7, only a brief
explanation is found here.
DATA LINK
OUT
PERSONALITY
A
1 2 3 4
1 2 3 4
Serial communcation
port
Figure 2-17. Locations of the other connectors on
the controller's rear panel.
Serial communication port: Connect the male end of a
standard 9-pin RS-232C serial communication cable to this
port for playback control using Lightwave Control Center
(LCC) software, or for backing up/restoring memories, pages
and presets using a personal computer. The port operates at
9600 baud, 8 data bits, no parity, and 1 stop bit. For more
details about using this port with LCC, see the section titled
"Lightwave Control Center" on page 6-31. For more
information about backup/restore, see Chapter 7.
Analog Inputs ports: Two locking 8-pin DIN connectors
that enable the remote recall of pages or presets using an
analog controller. The first connector is for analog channels
1 through 6; the second connector is for analog channels 7
through 12. For more details about the usage of this port, see
the section titled "Analog Inputs Ports" on page 6-15.
Studio Color LCD Controller
LIGHTWAVE RESEARCH
2217 West Braker Lane
Austin, Texas U.S.A.
MIDI
IN OUT
SERIAL PORT
MASTER SLAVE
RS-232
B
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Analog Inputs
ports
IMPORTANT SAFETY INFORMATION. SEE INSTRUCTION MANUAL BEFORE USE.
WICHTIGE SICHERHEITSINFORMATIONEN. BEDIENUNGSANLEITUNG VOR GEBRAUCH LESEN!
D'IMPORTANTE CONSIGNE DE SÉCURITÉ. VOYEZ LE MANUEL D'INSTRUCTION AVANT L'UTILISATION DE L'APPAREIL.
WARNING
To reduce t he risk of f ire or
electr ic shock, do not expose
t his device t o rain or mois ture.
ETL Listed
CAUTION
Conforms to
C
UL Std. 1950
R R
Certified to
To prevent electric shock, do
CAN/CSA C22.2 No. 950
not remove cover. No user
67501
serviceable parts inside.Refer
Cyberlight LCD Controller servicing to qualified service
MODEL
personnel. Replace fuse with
15FM123456
SERIAL
same type and rating.
230 50
VOLTAGE HZ
RA T I NG I N FO R MA TI O N
V O L TA G E : 1 1 5 V A C/ 2 3 0V A C
DATE QC CU RR E NT: 0 . 2 5A / 0 . 1 5 A
FR E Q UE NC Y : 5 0 -6 0 HZ
L
R
ANALOG INPUTS
STEREO
CAUTION
1-6 7-12
AUDIO
voltage
FUSE
INPUT
select
REMOTE
ENABLE
115 V 0.5 A, SLOW BLOW
230 V 0.315 A, SLOW BLOW
Stereo Audio Input
Remote Enable
port

Other Connectors 2-23

This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interferences,
and (2) this device must accept any interference
that may cause undesired operation.
port
2