Preparing To Program; Figure 4-1. Before Programming, Make Sure The - High End Systems High End LCD Controller for Studio Color User Manual

Preparing to Program

Before beginning any programming, make sure the controller
appears as shown below:
Standby LED off

Figure 4-1. Before programming, make sure the

controller's Address LED is ON, the Select and
Standby LEDs are both OFF, and the controller is
displaying the Intensity, Memory and Page.
Toggle the
Toggle the
Toggle the
showing in the LCD display.
Toggle the
Studio Color LCD Controller
Address LED on
Studio Color
ADDRESS
1 2 3 4
PRESET
5 6 7 8
STANDBY
slave 
   
POWER
 

MEMORY CARD
LIGHTWAVE
key until the Standby LED turns OFF.
<Standby>
key until the Address LED turns ON.
<Address>
key until Intensity, Memory and Page is
<Menu>
key until the Select LED turns OFF.
<Select>
LCD display shows Intensity, Memory,
Page
INTENSITY MEMORY PAGE
Intensity: 99 Memory: x Page: x
construct cursor page


 
      
home
     
select record erase
Select LED off

Preparing to Program

USER
2
1
4
3
5 6
7 8
ADVANCE
auto
level
rat e audio 4
4-3