Figure 2-15. Location Of The Master And Slave Ports On The - High End Systems High End LCD Controller for Studio Color User Manual

1. Set personality switch B-1 on the rear panel of each slaved
controller to ON. Refer to Figure 2-1 on page 2-2 for the
location of the switches. The Slave LED (located above the
Power key switch) turns ON.
2. Connect a shielded, 2-conductor cable with a 6 mm (1/4 inch)
tip/ring/sleeve connector on each end from the master
controller's Master (out) connector located on the rear panel
to the slave controller's Slave (in) connector.
3. To slave more than one controller to a master controller,
continue connecting cables from one controller to the next, as
shown in Figure 2-13 on page 2-18.
DATA LINK
OUT
PERSONALITY
A
1 2 3 4 1 2 3 4 5 6 7 8
1 2 3 4 1 2 3 4 5 6 7 8
Figure 2-15. Location of the Master and Slave ports
on the controller's rear panel.
Studio Color LCD Controller Master and Slave Controllers 2-21
LIGHTWAVE RESEARCH
2217 West Braker Lane
Austin, Texas U.S.A.
M IDI
IN OUT
SERIAL PORT
MASTER
SLAVE
RS-232
B
Master (out)
port
IMPORTANT SAFETY INFORMATION. SEE INSTRUCTION MANUAL BEFORE USE.
WICHTIGE SICHERHEITSINFORMATIONEN. BEDIENUNGSANLEITUNG VOR GEBRAUCH LESEN!
D'IMPORTANTE CONSIGNE DE SÉCURITÉ. VOYEZ LE MANUEL D'INSTRUCTION AVANT L'UTILISATION DE L'APPAREIL.
WARNING
T o reduce t he ri sk of f ire or
electr ic shock, do not expose
this device to rain or mois ture.
CAUTION
ETL Listed
Conforms to
C
UL Std. 1950
To prevent electric shock, do
R Certified to R
not remove cover. No user
CAN/CSA C22.2 No. 950
serviceable parts inside.Refer
67501
servicing to qualified service
personnel. Replace fuse with
MODEL Cy berlight LCD Controller
same type and rating.
15FM123456
SERIAL
230
VOLTAGE HZ 50
RAT ING IN FO R MAT IO N
V OL TA G E : 1 1 5V AC/2 3 0V AC
CURR ENT : 0.2 5A/0 .1 5 A
DATE QC F RE Q UE NCY : 5 0 -60 HZ
L
R
ANALOG INPUTS
STEREO
1-6 7-12
AUDIO
FUSE
INPUT
REMOTE
ENABLE
115 V 0.5 A, SLOW BLOW
230 V 0.315 A, SLOW BLOW
Slave (in)
port
This device complies w i th part 15 of the FCC rules.
Operation i s subject to the following two conditions:
(1) This device may not cause harm ful interferences,
and (2) this device mus t accept any interference
that may cause undesi red operation.
CAUTION
voltage
select
2