High End Systems High End LCD Controller for Studio Color User Manual page 62

• If the contents of memory and the RAM card do not
match, the message below is displayed. If you want to
save your programming to the RAM card, you must use
the backup instructions in Chapter 5.
6. If there is a RAM card containing operating system data in
the RAM card slot, the LCD display shows a message that
asks you whether or not you want to replace the controller's
operating system with the operating system saved on the
RAM card. Follow the instructions in the LCD display to
proceed. If you do not respond within a few seconds, the
controller performs its self-test.
7. If there is an incorrectly-formatted or blank RAM card
inserted, an error message is displayed. You do not need to
do anything; the controller will boot up normally.
8. After the RAM card operations, the controller performs a
self-test. The LCD display shows:
 as it runs the self-test. The self-test counts through the
memories from 1 to 9 slowly and then again quickly.
9. After the self-test, the controller's LCD display appears as
shown below:

10. At the same time, all connected fixtures are homed. Homing
a fixture returns the wheels to their home (default) positions;
and sets the dim, pan and tilt to their home (default) positions.
If any fixture fails to home, check its front panel display and
refer to the Studio Color User Manual for troubleshooting
suggestions.
2-28 Powering On the Controller
 

    
 
Studio Color LCD Controller