Setting The Switches; Configuring Switch Block A; Configuring Switch Block B; All Switches Off: Default Configuration - High End Systems High End LCD Controller for Studio Color User Manual

Setting the Switches

The two blocks of Personality DIP (dual in-line package)
switches located on the controller's rear panel are labeled A
and B.

Configuring Switch Block A

PERSONALITY
OFF
A B
1 2 3 4
1 2 3 4

Configuring Switch Block B

PERSONALITY
A B
ON
1 2 3 4 5 6 7 8
OFF
1 2 3 4 1 2 3 4 5 6 7 8

All Switches OFF: Default Configuration

The controller is shipped with all Personality "B" switches
set OFF, which configures the controller as follows:
• Master controller
• 60Hz input voltage frequency (see page 2-6)
• Page access (see page 2-6)
• Twelve-level preset access (see page 2-7)
• Dependent presets (see page 2-7)

Switch B-1: Master or Slave

Each controller supports up to 8 unique fixtures (8 fixtures
that can be programmed to operate independently of each
other). In order to expand your system to more than 8
independently-programmable fixtures, you can interconnect
master and slave controllers.

2-4 Setting the Switches

Switch block A is currently not used, and all four
switches must be set to the OFF position.
This section describes the functions of the eight
switches in Personality switch block B.
Studio Color LCD Controller