Programming Guided Tour; Recording - High End Systems High End LCD Controller for Studio Color User Manual

Programming Guided Tour

This section leads you step-by-step through creating a simple
four-page program, playing back the program page-by-page,
creating a loop and recording a preset. Only one fixture is
required, although you can use more than one if you wish.
Recording Page 1
1. Configure the controller and connect fixtures as described in
Chapters 1 and 2. Power ON fixtures then power ON the
controller if you have not already done so. Make sure the
controller appears as shown in Figure 4-1 on page 4-3.
2. Set the controller on memory 1, page 1 using the Cursor and
Page
<Up>
display below shows a controller set for memory 1, page 1:
3. Press the
4. Press the
For example, if you have one fixture set to fixture number 1,
press the
hold the starting fixture number key then press the ending
fixture number key.
5. Press the
<Down>
6. Press the
<Down>
position). Notice that the selected fixtures display the color
you selected.
7. Press the
<Down>
8. Use the joystick to position the beam to any location.
4-4

Programming Guided Tour

and arrow keys, respectively. The LCD
<Down>
key; it flashes.
<Select>
keys of the fixtures you want to program.
<Address>
key. To select a range of fixtures, press and
<1>
key, then use the Construct
<Gate>
arrow keys to select
key, then use the Construct
<Color>
arrow keys to select a color (not the open, or white,
key, then use the Construct
<Delay>
arrow keys to select a value of
<Up>
.
<Up>
<Up>
Studio Color LCD Controller
and
and
and
.