Setting Rate And Delay Time; Playing Back The Loop; Varying The Playback Rate - High End Systems High End LCD Controller for Studio Color User Manual

Setting Rate and Delay Time

Before continuing, make sure the controller is ready for
programming as shown in Figure 4-1 on page 4-3.
You can control the speed of your loop using the
and the Delay construct. The Delay construct (also called
delay time) determines how long each page in the loop
"plays" before moving on to the next page, and the
knob lengthens or shortens the delay time.
Note The Rate and Delay settings are ignored if you are
Using the
throughout this manual as auto advance.

Playing Back the Loop

1. Use the Page
the loop that you wish to begin with. (If you want the loop to
initially run from the first page on, select the first page; if you
want the loop to run from the third page on, select the third
page, and so on.)
2. Press the
LED comes ON and the loop runs beginning from the page
you selected.

Varying the Playback Rate

rate
longer than shorter than
Delay setting Delay setting

4-18 Setting Rate and Delay Time

using audio advance as described in the section titled
"Audio Input Playback" on page 6-27.
knob to control playback is referred to
<Rate>
and
<Up>
key located over the
<Auto>
While the loop is running, turn the
knob clockwise to run the loop faster or
counterclockwise to run the loop slower.
arrow keys to select a page in
<Down>
<Rate>
Studio Color LCD Controller
knob
<Rate>
<Rate>
knob. The Auto
<Rate>