Ram Card: Write-Protection - High End Systems High End LCD Controller for Studio Color User Manual

RAM Card: Write-Protection

After backing up either the operating system or memory to
the RAM card, you should write-protect that card to prevent
it from being inadvertently erased.
Examine the end of your RAM card to locate the small write-
protect tab. Also note the battery release, typically located
near the battery compartment. Do not disengage the battery
release, since that could cause the battery to fall out of the
RAM card.
Note Figure 7-1 below shows the RAM card shipped with
Figure 7-1 shows the locations of the write-protect tab and
the battery release on the RAM card that is being shipped
with the Studio Color LCD controller at the time of this
writing:
Write protect
Figure 7-1. Slide the write-protect bar to the right to
allow the RAM card to accept data, or move it to the
left to prevent it from accepting data.
7-12 RAM Card: Write-Protection
the Studio Color LCD controller (part number
80440017). Because of the wide variety of
compatible RAM cards available, you should consult
the documentation provided with your RAM card if
you are unsure of the location of its components.
tab
Write-protected
(locked)
MEMORY CARD
Not protected
Studio Color LCD Controller
Battery compartment
Battery release