Recording A Loop As A Preset - High End Systems High End LCD Controller for Studio Color User Manual

Recording a Loop as a Preset

Start the loop running, then assign the entire loop to one of
the Preset keys. For more information about loops, see the
section titled "Creating a Loop" on page 4-14.
1. Use the Page
within the loop that you want to record as a preset.
ADDRESS
2. Toggle the
PRESET
ON.
3. Press the
back the loop at the rate set by the
construct.
ADDRESS
4. Toggle the
ON. The LCD display then appears as shown below:
PRESET
5. Use the Cursor
of presets. Each bank contains 8 presets.
6. Press the
display appears as shown below:
7. Press the Preset key (
the loop. See Figure 4-5 on page 4-20 for an explanation of
how preset bank numbering works.
8. Optional. If you are using 12-level preset access, follow the
instructions in the section titled "Using Twelve-Level Preset
Access" on page 6-19.
9. Adjust the following settings; these settings are recorded as
part of the preset (you can change them later).
4-22 Preset Programming
and
<Up> <Down>
<Address>/<Preset>
key. The pages start advancing, playing
<Auto>
<Address>/<Preset>
and
<Right>
key. The Select LED flashes and the LCD
<Select>
to
<1>
arrow keys to select any page
key until the Address LED is
knob and the Delay
<Rate>
key until the Preset LED is
arrow keys to select a bank
<Left>
) on the front panel to store
<8>
Studio Color LCD Controller