Restoring The Operating System From A Ram Card - High End Systems High End LCD Controller for Studio Color User Manual

Restoring the Operating System from a RAM
Card
This section describes how to install an operating system
from a RAM card to the controller. You should use this
procedure if you are installing an updated or replacement
(same version) operating system. You can obtain updated
operating systems from your High End Systems dealer/
distributor.
1. Turn OFF the controller.
2. Insert the RAM card with the newer or replacement (same)
operating system version into the RAM card slot on the front
panel. The RAM card is designed to go in the slot only one
way; do not force the card into the slot. If you feel
resistance, turn the card over and reinsert it.
3. Turn the controller back ON.
4. The LCD display briefly shows the controller's boot version
number and then appears as shown below:
Note If the RAM card has the same operating system
5. The controller waits a short time for you to respond. If you
do not press either the
controller boots up normally with the existing operating
system.
6. Press the
operating system. The LCD display then appears as shown
below:
7-10 RAM Card: O/S
version, or if you are restoring a lost operating
system, different messages are displayed.
<Erase>
key to install the newer version of the
<Erase>
key or the
<Select>
Studio Color LCD Controller
key, the