Verifying The Transfer - High End Systems High End LCD Controller for Studio Color User Manual

9. A message is displayed on the Lightwave Backup software
menu when the transfer is complete. Press the controller's
key to complete the operation.
<Select>

Verifying the Transfer

Make sure the transfer was successful by checking the
programming on several pages in different memories you
know should have been changed. If the pages are
programmed as you expected, you are finished.
If the pages are not programmed as you expected, something
interrupted the file transfer. Do all of the following:
• Verify you selected the correct serial (COM) port as
described in the section titled "Initial Setup" on page
7-15.
• Check the cable connections on both ends, verify the
cable or replace it with a known working cable.
• Repeat the procedure, making sure not to press either
your computer's
key until the transfer has completed.
Studio Color LCD Controller
key or the controller's
<ESC>
IBM-Compatible 7-23
<Select>
7