Figure 2-14. Connect The Male End Of A 3-Pin Xlr Cable; Linking Fixtures To The Controller - High End Systems High End LCD Controller for Studio Color User Manual

be linked to a lighting console via its MIDI, RS-232C or
analog ports. Only the master controller (not the slaves) can
accept commands from the lighting console.
The system shown in Figure 2-13 can support up to 24
independently-functioning Studio Color fixtures (8 for each
of the three controllers). Also notice that fixtures are
numbered non-sequentially. The Studio Color LCD
controller recognizes fixtures numbered in any order you
wish, as long as all fixtures are numbered between 1 and 8.

Linking Fixtures to the Controller

1. Start with the controller. Connect 3-pin data-grade XLR
cable to its Data Out connector, as shown in Figure 2-14:
DATA LINK
OUT
PERSONALITY
A
1 2 3 4
1 2 3 4
Attach a male 3-pin XLR connector
Figure 2-14. Connect the male end of a 3-pin XLR
cable to the controller's female Data Out port.
2. Connect the female end of the XLR cable from the controller
to the first Studio Color fixture's male Data In connector.
3. Connect the male end of another XLR cable to the first
Studio Color fixture's female Data Out connector.
4. Continue connecting the Data Out connector from one Studio
Color to the Data In connector to the next Studio Color until
you have linked all of the Studio Color fixtures. It is not
necessary to connect fixtures in any particular order; connect
them in a way that results in the least amount of cabling.
Studio Color LCD Controller
LIGHTWAVE RESEARCH
2217 West Braker Lane
Austin, Texas U.S.A.
MIDI
I N OUT
SERIAL PORT
MASTER
RS-232
B
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
IM PORTANT SAFETY INFORM ATION. SEE INSTRUCTION MANUAL BEFORE USE.
WICHTIGE SICHERHEITSINFORMATIONEN. BEDIENUNGSAN LEITUNG VOR GEBRAUCH LESEN!
D'IMPORTANTE CONSIGNE DE SÉCURITÉ. VOYEZ LE MANUEL D'INSTRUCTION AVANT L'UTILISATION DE L'APPAREIL.
WARNING
T o reduce the ri sk of fi re or
electr ic shock, do not expose
t hi s device t o rain or mois ture.
ETL Listed
Conforms to
UL Std. 1950 C
R R
Cer tified to To prevent electric shock, do
CAN/CSA C22.2 No. 950 not remove cover.
67501
serviceable parts inside.Refer
servicing to qualified service
MODEL Cyberlight LCD Controller
personnel. Replace fuse with
SE RIAL 15FM123456 same type and rating.
VOLTA GE 230 HZ 50
RA T I NG IN F O R MA T IO N
V O LT A G E :
CU RRE NT :
DA TE QC
F R EQ UE NC Y: 5 0- 6 0 HZ
L
R
ANALOG INPUTS
STEREO
1-6 7-12
AUD IO
SLAVE
INPUT
REMOTE
ENABLE
115 V 0.5 A, SLOW BLOW
230 V 0.315 A, SLOW BLOW
Connecting Fixtures 2-19
This device compli es with part 15 of the FCC rules.
Operation is subject to the following two c onditions:
(1) This device may not cause harmful i nterferences,
and (2) this device must accept any i nterference
that may cause undesired operation.
CAUTION
No user
1 15 V A C/2 30V A C
0 .2 5A/ 0 .1 5A
CAUTION
voltage
FUSE
select
2