Crossload Procedure; Studio Color Lcd Controller - High End Systems High End LCD Controller for Studio Color User Manual

Consult Appendix C for a complete selection of cabling and
connector wiring diagrams.

Crossload Procedure

The source controller is the one you want to transfer data
from; the destination controller is the one you want to
transfer data to.
1. Toggle the
Standby LEDs come ON.
2. Press and hold the
(about 10 seconds) until its LCD display shows the
following:
3. Press and hold the
(about 10 seconds) until its LCD display shows the
following:
4. Press the
transfer. While the transfer is taking place, the LCD display
on the destination controller appears similar to the one shown
below:
Note Press the
7-32 Crossloading
keys on each controller until their
<Standby>
<Record>
<Erase>
key on the source controller to start the
<Record>
<Select>
order) at any time to stop the transfer. No data
corruption will result; stopping the transfer only limits
key on the source controller
key on the destination controller
key on each controller (in any

Studio Color LCD Controller