Master Dim - High End Systems High End LCD Controller for Studio Color User Manual

Master Dim

The sample LCD display below shows a value of
Intensity (also called master dim). The value of 99 is
maximum intensity (full bright) and 0 is the minimum
intensity (full dim).
You can change the intensity setting using the Construct
and
<Up>
controlled in the following ways:
• By a submaster as described in the section titled
"Submasters" on page 6-23. Also see the section titled
"Switch B-6: Dependent/Independent Presets" on page
2-7.
• By a master controller as described in the section titled
"Switch B-6: Dependent/Independent Presets" on page
2-7.
• Using channels 11 or 12 in binary preset access as
described in the section titled "Using Binary Preset
Access" on page 6-21.
• By Lightwave Control Center software. More
information about Lightwave Control Center is shown in
the section titled "Lightwave Control Center" on page
6-31.

4-28 Master Dim

arrow keys. Master dim can also be
<Down>
Studio Color LCD Controller
for