The Signal Display Grid - Teledyne LabMaster 10 Zi Series Getting Started Manual

The Signal Display Grid

The grid area is divided into 8 vertical divisions and 10 horizontal divisions
just like any other oscilloscope. Set up the signal display area by touching
Display → Display Setup... from the menu bar. The Display dialog offers a
choice of grid combinations and can also set the grid intensity.
There are several indicators on the grid to help you understand the
following:
The default setting (Time) is for delay readout (in seconds) and to move
proportionately when the timebase knob is turned. If you want to set delay
(Div) to a fixed position on the grid, and then have it stay fixed as the
timebase changes, go to Utilities → Preference Setup... and select the
Acquisition dialog to make the setting.
922561-00 Rev A
Trigger Delay - This indicator is located along the
bottom edge of the grid. Trigger delay allows you to
see the signal prior to the trigger time.
All trigger delay values (including post-trigger delay,
shown here) are displayed in the Timebase
Descriptor Label. Zero delay is the horizontal center
of the oscilloscope display.
Post-trigger Delay - This is indicated by a left-
pointing arrow to the lower-left of the grid. Pre-
trigger delay is indicated by a right-pointing arrow to
the lower-right of the grid.
Trigger Level - This indicator is located at the right
edge of the grid. It tracks the trigger level as you
reposition the trace up or down, or change scale.
When triggering is stopped, a hollow arrow indicates
Getting Started Manual
45