Advertisement
TFT Color Display
The generator can only display parameters and waveform of one channel at a time.
The picture below shows the interface when CH1 chooses AM modulation of sine
waveform. The information displayed may vary depending on the function selected.
2
1
3
5
7
4
6
1.Waveform Display Area
Shows the currently selected waveform of each channel. The key backlight will turn on
when this area of the touch screen is clicked.
2.Channel Status Bar
Indicates the selected status and output configuration of the channels. This area of the
screen is switch to the corresponding channel when the channel select key is pressed.
The display will then show the channels and the shortcut menus for the function keys:
Mod, Sweep, Burst, Parameter, Utility and Store/Recall.
3.Basic Waveform Parameters Area
Shows the current waveform's parameters of each channel. Press Parameter and
select the corresponding softkey to highlight the parameter you want to configure, use
number keys or knob to change the parameter value.
11
Advertisement
