Power-on Inspection
When the oscilloscope is connected to line power, press the power key at the lower-left
corner of the front panel to start the oscilloscope. During the start-up process, the
oscilloscope performs a series of self-tests and you can hear the sound of relays
switching. After the self-test is finished, the welcome screen is displayed.
To Connect the Probe
Teledyne Test Tools provides passive probes for the oscilloscopes. For detailed
technical information of the probes, please refer to the corresponding Probe User's Guide.
Connect the Probe:
1. Connect the probe to an oscilloscope front channel BNC.
2. Connect the probe tip to the circuit point to be tested and connect the ground alligator
clip of the probe to the circuit ground terminal.
User Manual 7