Heater And Temperature Probe Adjustment - Teledyne VISION G2 CLASSIC 6 User Manual

Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019
7. Slide the tensioner to add tension to the drive belt.
Proper tension will be when the belt can be gently
deflected 6-10 mm between spindles 5 and 6 on the
Elite 8, or spindles 2 and 3 on the Classic 6.
8. Replace the cover by aligning it over the spindles
and monument and then pressing down until it pops
back into place.
9. Reinstall the spindle shafts.

Heater and Temperature Probe Adjustment

1. Place an NIST traceable thermometer next to the
temperature probe.
2. From the home screen, touch the Menu button
followed by the Tools button.
3. Touch the Cal Temp button at the bottom of the
screen.
4. Locate the probe on the Instrument or Vessel
Probes tab and touch that field.
5. Use the numeric keypad to enter the temperature on
the NIST traceable thermometer, then touch OK.
Maintenance
122 of 158