Setting Up The Xscf Snmp Agent Function - Fujitsu SPARC Enterprise M4000 User Manual

7.4 Setting Up the XSCF SNMP Agent
Function
This section explains how to set up the XSCF SNMP agent function.
The workflow is as described below. Perform each setup step with the setsnmp (8)
command of the XSCF Shell. For details on setup, see
Starting Transmission
Step 1:
■
For setting items common to the agent protocols of SNMPv1, SNMPv2c, and
SNMPv3, specify the management information listed below.
The following setting items are reflected in the MIB information:
■
■
■
■
Step 2:
■
Specify the following management information for SNMPv3, SNMPv1, and
SNMPv2c:
[SNMPv3 management information settings]
■
■
■
■
■
■
Note – A user name, authentication password, and encryption password that are
common to both the sending and receiving sides must be set for SNMPv3.
[SNMPv1 and SNMPv2c management information settings]
■
7-8 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
Installation location of the agent system
Mail address of the administrator
Description of the agent system
Port number of the agent (listening port number)
User name (Note)
Authentication password (Note)
Encryption password (Note)
Authentication algorithm
Port number of the trap destination
Host name of the trap destination
Defined TRAP type (specify v1, v2c, or inform <v2c in your response>)
Chapter 2.