Fujitsu SPARC Enterprise M4000 User Manual page 106

SSH/Telnet Administration (Continued)
TABLE 2-9
Item Description
Display Display the timeout period for automatic
timeout logout.
timeout After logging in XSCF, if the system is not
used for a certain period, logout is
automatically performed. Specify the timeout
period (minutes). Note that no time
monitoring is performed while the domain
console is the current console.
Install/ Install and uninstall the SSH user public key.
Uninstall
One user can install multiple user public
user public
keys.
key
Note – To enable the SSH, to generate the host key, and to disable the telnet, the
XSCF reset is required. Please reset the XSCF using by rebootxscf (8) command.
After the XSCF reset, the XSCF session is disconnected. Please log in again to the
XSCF. The SSH or telnet settings are automatically applied to the standby XSCF Unit
for a system with a redundant XSCF configuration.
Note – In this system, the RW or RO consoles from multiple domains can be used.
Only one RW console can be used for each domain. Use the console (8) command
to specify either the RW console or RO console as a domain console. For details
about consoles, see
Enabling or Disabling SSH/Telnet
■
1. Use the showssh (8) command to display SSH settings or use the showtelnet
(8) command to display telnet settings.
2-50 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
Chapter
Command operation
Shell command
showautologout
setautologout
setssh
3.
Remarks
The default timeout period
is 10 minutes. A value
ranging from 1 to 255 can
be specified for the timeout
period.
When you install/
uninstall the user public
key, the useradm privilege
is required. (Note)