Fujitsu SPARC Enterprise M4000 User Manual page 258

Select POP authentication or SMTP authentication—(See setsmtp (8))
Reply address (from specification)—(See setsmtp (8))
Recipient address for mail for the system administrator—(See setemailreport
(8))
Step 3: Enable the XSCF mail function. (See setemailreport (8))
■
Step 4: Send test mail.
■
6-4 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
Test mail is automatically sent when the work for these mail settings is
completed. If the email message sent as test mail is confirmed to have been
received by the system administrator, it means that the correct settings have
been made. If the email massage is not received, error mail is sent to the reply
mail address (From:) or a record is made in an error log. In this event, identify
the cause of the error, correct it, and start from step 1 again.
Once the test is completed normally, the mail report function is enabled. Use
the showemailreport (8) command to check whether the test is completed.
For details on making settings for the SMTP server and name server, see
Chapter 2.