Connecting To Xscf Using Telnet Via The Lan Port - Fujitsu SPARC Enterprise M4000 User Manual

b. Follow
c. Perform the console (8) command.
d. Confirm that the RW console or RO console window is displayed.
3.1.6 Connecting to XSCF Using Telnet via the LAN
Port
The procedure described below assumes that telnet is enabled in the SSH/telnet
settings of XSCF, as described in
the server and a LAN and the connection between a PC and workstation, see the
Service Manual for your server.
The following is the procedure for connecting to a terminal using telnet via the
XSCF-LAN port.
1. Confirm that the LAN cable is inserted into the XSCF-LAN port connector on
the front of the XSCF Unit, or confirm that the PC and workstation to be used
are correctly connected.
2. On the PC or workstation to be used, use one of the following procedures:
■
FIGURE 3-3
a. To establish a telnet connection, activate the terminal emulator and specify
b. Enter an ID and password to start the XSCF Shell.
Step a to Step d
Connecting the XSCF Shell terminal
Example of Starting the Terminal Emulator
the IP address of XSCF and port number 23. In the systems with redundant
XSCF Units, specify the IP address of active XSCF.
in the above "Connecting the XSCF Shell
Chapter 2. For details on cable connections between
Chapter 3 Connecting to the XSCF and the Server
terminal."
3-9