Fujitsu SPARC Enterprise M4000 User Manual page 285

4. Import XCP.
a. Display the XCP import window.
b. Following instructions in the window, specify the firmware program
(tar.gz) file and import XCP to the system.
(The update is not performed at this point.)
5. If complete message is displayed, the XCP importing has ended. Perform the
firmware update.
(The XSCF firmware is downloaded and applied, and the OpenBoot PROM
firmware is downloaded.)
a. Make a selection for the XCP update. (The version of the imported XCP
firmware and the version of the firmware currently running has already
displayed in the screen.)
b. Make a selection for the firmware version check. Confirm whether or not it
is possible to update to the new firmware version.
c. Make a selection for the firmware update. Following instructions in the
window, update the firmware.
(Only application of the XSCF firmware is completed.)
Note – In a system with redundant XSCF Units:
i) Perform the firmware update in order, beginning with the standby side and then
the active side automatically. After the update on the standby side is completed, the
active and standby sides are switched. At this time, the XSCF reset is done and the
XSCF session is disconnected.
ii) Re-connect the XSCF and log in again.
iii) XSCF firmware update is completed.
d. Refer to the Monitor message log to confirm that the XSCF firmware update
has finished.
6. To complete the update of the OpenBoot PROM firmware, restart the domain.
7. Confirm that the version of the system firmware that is running is that of the
firmware applied from the XSCF Web console.
Chapter 8 Upgrade of XSCF Firmware and Maintenance 8-15