Fujitsu SPARC Enterprise M4000 User Manual page 78

(See applynetwork (8), rebootxscf (8).)
Note – While any of the setting commands concerning the XSCF are in execution, if
the XSCF failover is generated, the setting may not be completed. Log in to the
active side XSCF again to confirm whether or not the setting is applied. If the setting
is not applied, perform the setting again.
Enabling or Disabling the XSCF Network and Specifying an IP Address
and Netmask for the Network and DSCP
Command operation
■
1. Use the shownetwork (8) command to display network interface information.
<Example 1> Display information on all network interfaces of XSCF.
XSCF> shownetwork -a
<Example 2> Display information on network interfaces of LAN#1 in the
XSCF Unit #0 (XSCFU#0).
XSCF> shownetwork xscf#0-lan#1
xscf#0-lan#1
Link encap:Ethernet
inet addr:192.168.10.11
UP BROADCAST RUNNING MULTICAST
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:20241827 (19.3 MiB)
Base address:0xe000
<Example 3> Display the ISN information on network interfaces of XSCFU#0
XSCF> shownetwork xscf#0-if
xscf#0-if Link encap:Ethernet
inet addr:192.168.10.128
UP BROADCAST RUNNING MULTICAST
RX packets:54424 errors:0 dropped:0 overruns:0 frame:0
TX packets:14369 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B)
Base address:0xe000
<Example 4> Display the takeover IP address information of the XSCF-LAN#0
XSCF> shownetwork lan#0
lan#0 Link encap:Ethernet
inet addr:192.168.1.10
UP BROADCAST RUNNING MULTICAST
Base address:0xe000
2-22 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
HWaddr 00:0A:48:09:C9:0E
Bcast: 192.168.10.255
MTU:1500
TX bytes:2089769 (1.9 MiB)
HWaddr 00:0A:48:09:C9:1E
Bcast:192.168.10.255
MTU:1500
TX bytes:17010 (16.6 KiB)
HWaddr 00:00:00:12:34:56
Bcast:192.168.1.255
MTU:1500
Mask:255.255.255.0
Metric:1
Mask: 255.255.255.0
Metric:1
Mask:255.255.255.0
Metric:1