Fujitsu SPARC Enterprise M4000 User Manual page 241

XSCF Commands (Continued)
TABLE 5-1
Command
setdomainmode
showdomainmode
sendbreak
showresult
setlocale
showlocale
setaltitude
showaltitude
cfgdevice
addcodlicense
deletecodlicense
showcodlicense
showcodusage
setcod
showcod
console
showconsolepath
showenvironment
showstatus
showhardconf
poweron
poweroff
reset
setpowerupdelay
Description
Sets a hardware initial diagnostic level (No, standard, maximum).
Enables or disables break signal sending, host watchdog, and automatic boot.
Displays the hardware initial diagnostic level.
Displays information of enabled or disabled status on break signal sending, Host
watchdog , and automatic boot.
Sends a break signal to the server.
Displays the exit status of the most recently executed command.
Sets locale.
Displays locale.
Sets altitude.
Displays altitude.
Sets the connection destination of the DVD drive unit and tape drive unit. Displays
the setting status information.
Applies the license key obtained from the license center to the system.
Deletes the license key applied to the system.
Displays the license keys applied to the system.
Displays license usage information.
Configures COD settings.
Displays COD settings.
Connects to a domain console.
Displays the operating status of the main console.
Displays the temperature, humidity, voltage, and fan rotation speed.
Lists degraded components.
Displays all components mounted in the server.
Turns on power to all domains or the specified domain.
Turns off power to all domains or the specified domain.
Resets the specified domain.
Note: The following three reset modes are available:
por: Domain system reset
request: Domain panic instruction
xir: Domain CPU reset
Sets the warm-up time and the air-conditioning wait time.
Chapter 5 Overview of the XSCF Shell 5-5