Sending A Domain Panic Request - Fujitsu SPARC Enterprise M4000 User Manual

Also, even if a system abnormality (like a fan or temperature abnormality) is
detected while the OS is being booted, or the system is running in single user mode,
there may be cases where the power cannot be turned off. (An OS shutdown is not
executed.) In such cases, immediately perform the procedure above.
4.4.5

Sending a Domain Panic Request

■
1. Use the showdomainstatus (8) command to check the power status of the
domain to which a panic instruction is to be issued.
XSCF> showdomainstatus -a
DID
00
01
02
03
2. Use the reset (8) command to issue a panic instruction to the specified
domain.
<Example>
XSCF> reset -d 0 panic
DomainID to panic:00
Continue? [y|n] :y
00 :Panicked
*Note*
This command only issues the instruction to reset.
The result of the instruction can be checked by the
"showlogs power".
4-14 SPARC Enterprise Mx000 Servers XSCF User's Guide • April 2008
Command operation
Domain Status
Running
Running
Running
Running
Issue a panic instruction to the specified domain.